"Igor" pumpKin

PUBLISHED ON 10/03/13 BY francisco ramirez
PRINT DIFFICULTY: intermediate| PRINT TIME: medium| MULTIPLE PARTS: NO| SUPPORT MATERIAL: required| SEE ALL PRINT PARAMETERS
A Halloween jack-0-lantern design ready to be printed.
The idea behind this design, is to place them alongside your walkway to the front door of your home, while placing X=Mas lights/Halloween lights ... [READ MORE]underneath them to light up your pathway. Making it easier for trick or "treaters" to find their way!
Made the insides hollow to place light bulb or a led light inside. Also has a small opening on the bottom-back of the design to allow wire access for the bulb. Thick enough to keep the design sturdy.
When test printed:
- For support structures use Slic3r's default settings, that way the supports come out across the mouth (in front of the teeth).
- Should not be time consuming to take off the structures. Will take maybe 5 minutes, more or less to remove them.

LESS

PAYMENT OPTIONS

LICENSE LEVEL PRICE
Allows the buyer to print up to 100 copies for home use only. Purchasers cannot distribute or sell the printed items and they cannot distribute or sell the digital design. If they wish to print more than 100 copies they must buy multiple licenses.
$1.99

PRINTING INSTRUCTIONS

PRINT PARAMETERS

  • PRINT DIFFICULTY: intermediate
  • PRINT TIME: medium
  • SUPPORT MATERIAL: required
  • MIN # OF EXTRUDERS: 1
  • LARGEST PRINTABLE PIECE: 73 x 78 x 84 (mm)
  • SCALEABLE: YES
  • MULTIPLE PARTS: NO
  • FINISHING TIME REQUIRED: YES, 10min
  • RECOMMEDED MATERIALS: PLA, PVA