3Dponics-Venturi

PUBLISHED ON 12/07/15 BY 3Dponics
PRINT DIFFICULTY: beginner| PRINT TIME: short| MULTIPLE PARTS: NO| SUPPORT MATERIAL: no| SEE ALL PRINT PARAMETERS
"An improved version of the original conduit that takes the principles of fluid dynamics and applies them to hydroponics, allowing water to flow more efficiently to the top of your 3Dponics system. The ... [READ MORE] shorter pipe acts as the air intake (attaching to the air bubbler via rubber tubing); the longer pipe acts as the outlet (transporting water to the top of the system).

For optimal performance, the Venturi should be placed vertically inside the reservoir, immersed in the nutrient solution.

Bonus: The Venturi is smaller than the Conduit and therefore takes less time and material to print. If you have a dual outlet pump (e.g. HagenMarina 200), you can power two or more 3Dponics systems with one air pump.

Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260)

Want to know how much it would cost to print this part? Visit https://www.3Dprintler.com and compare prices from today's top 3D-printing services."

LESS

PAYMENT OPTIONS

LICENSE LEVEL PRICE
Allows the buyer to print up to 100 copies for home use only. Purchasers cannot distribute or sell the printed items and they cannot distribute or sell the digital design. If they wish to print more than 100 copies they must buy multiple licenses.
FREE

PRINTING INSTRUCTIONS

PRINT PARAMETERS

  • PRINT DIFFICULTY: beginner
  • PRINT TIME: short
  • SUPPORT MATERIAL: no
  • MIN # OF EXTRUDERS: 1
  • LARGEST PRINTABLE PIECE: 18 x 9 x 46 (mm)
  • SCALEABLE: YES
  • MULTIPLE PARTS: NO
  • FINISHING TIME REQUIRED: NO
  • RECOMMEDED MATERIALS: NONE LISTED