3Dponics-Drip-Emitter-Wings-V3-1

PUBLISHED ON 12/07/15 BY 3Dponics
PRINT DIFFICULTY: beginner| PRINT TIME: short| MULTIPLE PARTS: NO| SUPPORT MATERIAL: no| SEE ALL PRINT PARAMETERS
Version 3 of the Drip Emitter is an upgraded version of V2. It is used to drain excess water from pots that have a hole at the bottom. It fits snuggly inside the hole--all you have to do is snap it int ... [READ MORE]o place. For an extra secure seal, you can use silicone around the edges. You can then connect a long piece of tubing to the end of the Emitter and direct it into a large container or reservoir, which will collect the excess water. It has a thicker nozzle, which allows for a better fit with the flexible tubing. This version of the emitter has wings that give you a better grip. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level! Ready to print this part? Compare 3D-printing prices across today's top service providers and get the lowest price for your 3D-printing project. Get your quote now at https://www.3Dprintler.com.

LESS

PAYMENT OPTIONS

LICENSE LEVEL PRICE
Allows the buyer to print up to 100 copies for home use only. Purchasers cannot distribute or sell the printed items and they cannot distribute or sell the digital design. If they wish to print more than 100 copies they must buy multiple licenses.
FREE

PRINTING INSTRUCTIONS

PRINT PARAMETERS

  • PRINT DIFFICULTY: beginner
  • PRINT TIME: short
  • SUPPORT MATERIAL: no
  • MIN # OF EXTRUDERS: 1
  • LARGEST PRINTABLE PIECE: 30 x 20 x 21 (mm)
  • SCALEABLE: YES
  • MULTIPLE PARTS: NO
  • FINISHING TIME REQUIRED: NO
  • RECOMMEDED MATERIALS: NONE LISTED