3Dponics-Drip-Emitter-Bolt-V1-1

PUBLISHED ON 12/07/15 BY 3Dponics
PRINT DIFFICULTY: beginner| PRINT TIME: short| MULTIPLE PARTS: NO| SUPPORT MATERIAL: no| SEE ALL PRINT PARAMETERS
Version 1 of the Drip Emitter is used with pots that have a hole at the bottom and allows you to drain excess water from the pot and channel it into a reservoir using a piece of tubing that's attached ... [READ MORE]to the Bolt. To install, start with an empty pot. Insert the Bolt into the hole at the bottom of the pot and screw the Nut to the Bolt from inside the pot. Connect a long piece of tubing to the outer end of the Bolt and direct it into a large container or reservoir, which will collect the excess water. The Drip Emitter V1 can also be used to convert any pot with a hole at the bottom into a standalone circulating hydroponics system. All you need to do is to connect the 3Dponics Siphon or Venturi to an air pump, place the siphon into the reservoir and connect a piece of tubing that brings water up to the plant. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level! Ready to print this part? Compare 3D-printing prices across today's top service providers and get the lowest price for your 3D-printing project. Get your quote now at https://www.3Dprintler.com.

LESS

PAYMENT OPTIONS

LICENSE LEVEL PRICE
Allows the buyer to print up to 100 copies for home use only. Purchasers cannot distribute or sell the printed items and they cannot distribute or sell the digital design. If they wish to print more than 100 copies they must buy multiple licenses.
FREE

PRINTING INSTRUCTIONS

PRINT PARAMETERS

  • PRINT DIFFICULTY: beginner
  • PRINT TIME: short
  • SUPPORT MATERIAL: no
  • MIN # OF EXTRUDERS: 1
  • LARGEST PRINTABLE PIECE: 15 x 17 x 30 (mm)
  • SCALEABLE: YES
  • MULTIPLE PARTS: NO
  • FINISHING TIME REQUIRED: NO
  • RECOMMEDED MATERIALS: NONE LISTED